E46 M3 camber / caster plate

xenon height sensor relocation

Step 1: remove existing link between passenger lower control arm and black sensor box.
Step 2: remove box and bracket. Both will be reused with no modifications.
Step 3: drill 3/16 hole as shown by drill bit in photo below.
            drill 1.8 inches back from the front edge of the brake line bracket, and 0.5 inches      inward from the outer edge

Step 4: reuse existing nut, washer and bracket to bolt to new hole as shown
Step 5: attach new longer link as shown below.
Step 6; readjust headlight height with dial on the rear of each headlight